When you have to remove the nib and feed from a pen section, the knock out block is an essential tool.
First soak your section, this will soften the old hard ink around the nib.
Place the section with the nib downwards into the correct size whole for the nib.
Take one of the knockout rods that is just smaller than the feed that is showing and gently tap down with a small light weight hammer until the feed and nib slide out of the section.
Some nibs are screw in and come within there own sleeves
It is not advisable to try and remove these nibs from there sections and sleeves
With this type of nib removal knock out tool.
The block is 3 ¼ inches (8.4cm approx) tall and 2 ⅞ inches (7.3cm approx) in diameter.
There are 8 knockout holes ranging from 3.8mm to 11.2mm in diameter.
The 3 rods are stored in their own holes. Rod diameters are 3.3mm 4.7mm and 6.3mm in diameter. All rods are 3 ¾ inches (9.5cm) in length.
We now have spare Knock Out Plates and Rod sets. Plus replacement single rods available, just choose from the drop down menu.
