This Anchor / Hanging pressure bar fits in the barrel via the button end.
Once the new sac has been fitted and the section replace back into the barrel this pressure bar is then fitted.
A thin flexible rod should be used to compress the sac while fitting, thus ensuring the bar slips inside the barrel and that the sac is not snagged.
It goes through the hole and just clips onto the side with the flat end resting on the lip.
It can only be fitted one way so always in the correct position.
A three piece construction, the additional part contains the flat anchor plate that sits on the button collar opening.
The whole bar is held in place by the button once refitted.
These bars do not require the any resistance from the end of the section as they fully operational once fixed at the end by the button.
Fits many makes of button filler pen. Both Screw in and friction fit section. This pressure bar is not suitable for pens with PLASTIC BUTTONS.
Available as a Large or Medium size.
Medium 6.2 cm in length.
Small 5.6 cm in length.
IMPORTANT:: Over the years dirt may have accumulated on the inside of the Button hole, make sure this is cleaned before fitting the Anchor bar to ensure a proper fit. The hole should be 5 mm in diameter.
ALL these Bars are newly manufactured to the original specifications.